hroman:rx7:2nd gen ignition

This project is pending my winter project of cleaning the intake. Basically it's to setup a 2nd Gen DLIDFIS on my 1st gen.
width='133'
Leading Coil from 2nd Gen
Here it is opened up.
width='133'
Tools and supplies
Soldering iron, plastic shrink tubes and wiretap clips.
width='133'
Leading Coil
Rip out the ignitor inside.
width='133'
Leading Coil
Cut the wires what will not be used.
width='133'
Leading Coil
Solder the positive line to the resistor like so.

Thanks goes to inittab for helping in setting this up.
Powered by photo album generator a tool written by David Ljung on Wed Nov 2 15:09:24 2005